Thingiverse
Retropie 10 Inch
von XrayOne911
37
Downloads
33
Likes
0
Makes
This is the first attempt at a 10 inch retropie tablet / handheld.
Raspberry PI Zero W will be used.
The controller will later be an iPega PG-9055 used later
The display is in test mode on one screen. The place holder was an old tablet case
Display Driver Board needs a few modifications. Remove VGA / DVI Connector, The caps are too high and need to be extended with cable. Thereafter, the board fits from the height into the case
As seen in the picture!!
Display is a 10 inch IPS Ultra Slim
https://www.amazon.com/dp/B00VE72DLC
Raspberry PI Zero W will be used.
The controller will later be an iPega PG-9055 used later
The display is in test mode on one screen. The place holder was an old tablet case
Display Driver Board needs a few modifications. Remove VGA / DVI Connector, The caps are too high and need to be extended with cable. Thereafter, the board fits from the height into the case
As seen in the picture!!
Display is a 10 inch IPS Ultra Slim
https://www.amazon.com/dp/B00VE72DLC
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!