REV Driver Hub Cover

Slip on cover for REV Driver Hub (https://www.revrobotics.com/rev-31-1596/). Print with TPU flexible filament. A little tight to slip on. Leaves battery compartment and majority of ports open. Printed with organic supports (Prusa). Required a lot of trimming to remove supports, but works fine.

Recommend replacing M3 screw on battery compartment with M3x6 thumb screw (e.g. https://www.amazon.com/dp/B01H0CNGJ2).

What drove the design was the battery issues with the Driver Hub and the need to pull the battery just to turn it on. After replacing the built in battery compartment screw with the thumb screw, the device no longer sits flat. The case lifts the hub off the table.

For my solution to the battery/charging issue:
I've run into a bug in Android based devices in the past (outside of FTC) where if the battery is dead, the device won't turn on. However, if you remove a battery from the device and power it through the charge port it will turn on. So my recommendatio