Rev's Tablet Helper

My wife had me make her one of the little phone finger holders, and while I was looking at it I thought “this could be better, and bigger…” The intent is basically the same as the phone holders, but with a longer stem to allow you to hold a tablet more center-of-mass. I put a bit of time in to flaring the finger holes at just the right angles to properly reflect the natural lines of an open hand and rounding out surfaces which touch the webbing of your fingers to make it a more pleasant thing to use with heavier devices. This is a problem for me, as I'll spend time holding my tablet supported on my pinky at an uncomfortable angle. Having used this last night and some today, I'm really happy with it! Only took four tries to get it right 😂Prints great in PETG, would be fine in PLA. Additive (-CF, etc) filaments might be skin-irritant though, so I'd advise against them.