Revo 3.3 Reverse Gear

Prints best for me with these settings using ender 3 pro with
.04mm nozzle
215c for filament
65c for the bed
PLA
100% infill
15% overhang threshold
4 perimeters

When done printing use a small screw driver to take out supports and a hobby knife to clean between the gear teeth, when pressing the bearing into the gear make sure it goes all the way into the gear (using a vise if possible its a very tight fit) a little past flush with the mesh side other wards it will not work, also make sure that the output shaft is rotating freely when screwing the transmission back together, may have to leave the screws a small bit backed out about 1/2 a turn backed out from tight all around.