Reworked malfeasance Trigger

I wanted a more "functional" prop of Malfeasance. So after tweaking the hammer, I've figured out a design that seemed to work. The seer face is quite finicky and you may need to print the part a few times. This essentially changes your malfeasance into a "double action" revolver. I would HIGHLY recommend to tape together the main body to make it easy to take apart to test the trigger.

Build instructions:
1. Print hammer rework file.
2. Place a spring from a cheap and free ballpoint pen that you could get pretty much anywhere (banks especially) into the pocket as shown in the picture
3. Test if the hammer works. If not, it's likely that you'll need to do some fine tuning with an x-acto knife.

P.S. This is only the first iteration. So I'll need to revisit this another time to get it to work better.