Thingiverse
Rey Staff End Cap
door Foreverwinter
20
Downloads
20
Likes
0
Makes
This re-mix involves 2 small modifications:
- The bottom few mm was cut off to prevent any overhangs when printing
- Top was cut off to create a flat spot (21mm in diameter)
I used the flat spot on top to stick a clear rubber foot to prevent sliding and/or scratching when resting the staff on the floor.
Great thanks to Delphius for the fantastic model!
- The bottom few mm was cut off to prevent any overhangs when printing
- Top was cut off to create a flat spot (21mm in diameter)
I used the flat spot on top to stick a clear rubber foot to prevent sliding and/or scratching when resting the staff on the floor.
Great thanks to Delphius for the fantastic model!
Foreverwinter publiceert ook op
17 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
