Thingiverse
RFID Badge Caddy
von paxanders
20
Downloads
12
Likes
0
Makes
Was given a new RFID badge at work. Project has gone from concept and design to small-scale manufacturing and sale.
Two credit cards and a laminate sheet will fit into the slot. Reference for RFID included (not to scale)
Hoop has been strengthened from earlier prototypes; hasn't broken off mine yet.
Tried to go for a corporate look. The three lines across the back add a nice feel and additional strength. The hex detail on the front comes out best when printed on an angle.
I am proud of this project, it has been a good stepping stone in my 3d design education.
Recommended re-sale value of $10
I donate 100% of profit to the 503c makerspace I volunteer at, the sale of these has allowed us to purchase large amounts of filament and parts.
Cruces Creatives
Two credit cards and a laminate sheet will fit into the slot. Reference for RFID included (not to scale)
Hoop has been strengthened from earlier prototypes; hasn't broken off mine yet.
Tried to go for a corporate look. The three lines across the back add a nice feel and additional strength. The hex detail on the front comes out best when printed on an angle.
I am proud of this project, it has been a good stepping stone in my 3d design education.
Recommended re-sale value of $10
I donate 100% of profit to the 503c makerspace I volunteer at, the sale of these has allowed us to purchase large amounts of filament and parts.
Cruces Creatives
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!