RFID Badge Holder

This is a remix of **jrebeiro**'s ID card holder, sized for one regular card and one thicker RFID card.

In my case the cards already had a hole through the top so having one on the holder was redundant. I pulled it into Tinkercad and made short work it. While I was doing that I angled the channels so the cards can slide in easier. Then brought it into Meshmixer to round off the corners and smooth the sharp edges.

I cut off the metal clip from my lanyard, and reattached the ends with some super glue. I flipped it over so the card slides in on the back to give the front side a finished look, all the way around.