Thingiverse
RFID Kids Jukebox
par d7071
3
Téléchargements
4
Likes
0
Makes
I started to build a Jukebox for my kid.
Check https://github.com/MiczFlor/RPi-Jukebox-RFID for instructions.
Just get a raspberry, a RFID card reader and some optional sound card. I used a HifiBerry and a small speakers.
Of course a housing must be provided and no doubt it had to be 3D printed.
The housing holds the speakers in the front with the rfid reader. It provides a reading slot and an extra slot for storing the RFID cards.
I used a power bank for DC supply, tied to the bottom lid of the center section.
I used brass nuts in the front and back cover which were melted into the PLA using a soldering iron.
This is an initial version.
Next steps planned are extra opening lid for maintenance and replacing of the SD card, extra mounting wholes for ON/OFF switch and USB recharge socket. The latter one were just cut out later on.
Check https://github.com/MiczFlor/RPi-Jukebox-RFID for instructions.
Just get a raspberry, a RFID card reader and some optional sound card. I used a HifiBerry and a small speakers.
Of course a housing must be provided and no doubt it had to be 3D printed.
The housing holds the speakers in the front with the rfid reader. It provides a reading slot and an extra slot for storing the RFID cards.
I used a power bank for DC supply, tied to the bottom lid of the center section.
I used brass nuts in the front and back cover which were melted into the PLA using a soldering iron.
This is an initial version.
Next steps planned are extra opening lid for maintenance and replacing of the SD card, extra mounting wholes for ON/OFF switch and USB recharge socket. The latter one were just cut out later on.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !