Thingiverse
RG35XXSP Display
by GameBoyMike
5
Downloads
12
Likes
0
Makes
This is a modification of Decal7's RG35XXSP Display stand.
I had three goals with this remix:
1. Hold the device at a slight angle so it can be displayed in an open or closed position (while remaining relatively stable).
2. Increase the size of the pocket to allow for easier insertion.
3. Shrink the front wall of the pocket to showoff more front artwork.
The display stand is extremely stable with the console in a closed position, and "mostly" stable with it in the open position.
I have also uploaded an "extra stable" version that provides better balance and stability when the device is displayed in the open position but increases the footprint. Personally, I don't think it's necessary, but if your shelf is at an odd angle or is susceptible to vibrations, it will work better.
The model seen in the pictures is the original version. It was sliced using Cura's "Balanced - Normal" preset and took 2 hours to complete.
I had three goals with this remix:
1. Hold the device at a slight angle so it can be displayed in an open or closed position (while remaining relatively stable).
2. Increase the size of the pocket to allow for easier insertion.
3. Shrink the front wall of the pocket to showoff more front artwork.
The display stand is extremely stable with the console in a closed position, and "mostly" stable with it in the open position.
I have also uploaded an "extra stable" version that provides better balance and stability when the device is displayed in the open position but increases the footprint. Personally, I don't think it's necessary, but if your shelf is at an odd angle or is susceptible to vibrations, it will work better.
The model seen in the pictures is the original version. It was sliced using Cura's "Balanced - Normal" preset and took 2 hours to complete.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
