MakerWorld
Office
Vai al Modello
RGB Headphone Stand
2
Download
3
Likes
0
Makes
Hello everyone, Today, I’m bringing you a 3D model of a headphone stand that I designed, which also allows for the addition of RGB or white LED strips. The LED strip width should not exceed 1 cm—other than that, all good! I’ve been working on this model for a while, but it’s not fully finished yet. For example, the base is missing a hole for a USB Type-C port, though you can also add batteries directly into the base since there’s enough space. There are various holes in the print to route the wires down to the base. I used two LED strips—one on the outer arch and a smaller one in the middle circle, where the strip is placed vertically to fit the circular shape. If you have any questions, please leave a comment, and I promise to make the necessary adjustments in the next version. Good luck!Boost MeThanks for the boost! I truly appreciate it from the bottom of my heart!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!