Thingiverse
RGB strip Tools
8
Downloads
5
Likes
0
Makes
A few tools for led strip management.
1. Corner holder - If led strip crosses a corner, it will unstick over time, this should prevent it. Mounts with one screw.
2. Flat wire holder - when soldered on running strip, high chance you will accidentally rip off the cables, and led strip with them. This should prevent it, as well as give better look.
3. All-in-one holder - universal bracket to:
a. Prevent end of strip to unstick, due to pull in the wire
b. Hold IR/WiFi receiver box, instead of taping/screwing it on the table
c. (Optionally) Provide stck-out holder for IR receiver
Mounts with upto 3 screws, depending on fillment %, 1 screw could be enough
Designed in Fusion360
1. Corner holder - If led strip crosses a corner, it will unstick over time, this should prevent it. Mounts with one screw.
2. Flat wire holder - when soldered on running strip, high chance you will accidentally rip off the cables, and led strip with them. This should prevent it, as well as give better look.
3. All-in-one holder - universal bracket to:
a. Prevent end of strip to unstick, due to pull in the wire
b. Hold IR/WiFi receiver box, instead of taping/screwing it on the table
c. (Optionally) Provide stck-out holder for IR receiver
Mounts with upto 3 screws, depending on fillment %, 1 screw could be enough
Designed in Fusion360
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!