MakerWorld
Other Tools
Zum Modell
ribbon bobbin spool replacement
17
Downloads
5
Likes
10
Makes
I designed this as a replacement spool, bobbin, or casing for ribbon, thread or any assorted string. I also added a larger version that needs printed on 2 plates. the original is about 3 and ¼ in wide by half in thick with no hole in the center. the large version is about 6 ½ in wide and an inch thick with a small hole in the center. I use one for ribbon and one for large spools of bias tape. i also added in small slits along one side to tuck the end of the ribbon into.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!