Thingiverse
Ribbon Cable Clip
by monstarmike
9
Downloads
8
Likes
0
Makes
UPDATE:
I've added a v2 for the clasp. The wires are inserted into the other side and then the clasp is placed on to the clip. This prevents the wires from falling out over time.
This is a two part clip that wraps around a ribbon cable. It fits ribbon cables 26mm in width. The clasp has a holder for wires.
This was designed for a printer that had ribbon cables connecting to the hot-end carriage. The clasp side has a place to hold wires. This was used to guide the 5 wires for a BLTouch.
While it was designed for a 3D printer there is probably many uses for this guy.
I've added a v2 for the clasp. The wires are inserted into the other side and then the clasp is placed on to the clip. This prevents the wires from falling out over time.
This is a two part clip that wraps around a ribbon cable. It fits ribbon cables 26mm in width. The clasp has a holder for wires.
This was designed for a printer that had ribbon cables connecting to the hot-end carriage. The clasp side has a place to hold wires. This was used to guide the 5 wires for a BLTouch.
While it was designed for a 3D printer there is probably many uses for this guy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
