Thingiverse
Right Angle Ethernet Cable Holder
door MCH170
90
Downloads
220
Likes
0
Makes
[For more information visit my website.](https://www.mch170.com/3d_models/right_angle_cable_holder)
This is a cable holder that holds your ethernet (or any other) cable at a 90 degree angle. It is useful if you want to bend your ethernet cable in a tight space without adding extra stress on the ethernet port.
The holder can clip shut but some epoxy or superglue is recommended is you want to be 100% sure.
It supports cables up to 7mm in diameter. Smaller ones also work (tested with 5mm).
This is a cable holder that holds your ethernet (or any other) cable at a 90 degree angle. It is useful if you want to bend your ethernet cable in a tight space without adding extra stress on the ethernet port.
The holder can clip shut but some epoxy or superglue is recommended is you want to be 100% sure.
It supports cables up to 7mm in diameter. Smaller ones also work (tested with 5mm).
MCH170 publiceert ook op
13 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
