Thingiverse
RigidBot Cooling Fan
von jwolee
149
Downloads
186
Likes
10
Makes
Cooling fan for the Rigidbot.
A must for ABS printing to keep prints from warping.
Even PLA warps too, and a cooling fan will "set" the filament as it's extruded.
If you can't get the posts to fit or print well, you can cut them off and tape the fan on.
I may upload a bolt screw-in version in the near future if there are enough requests.
A must for ABS printing to keep prints from warping.
Even PLA warps too, and a cooling fan will "set" the filament as it's extruded.
If you can't get the posts to fit or print well, you can cut them off and tape the fan on.
I may upload a bolt screw-in version in the near future if there are enough requests.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
