RigidBot E3D Mount
von jbolbach
0
Downloads
1
Likes
0
Makes
Mount an E3DV6 (or compatible) hot-end to your single or dual extruder RigidBot.
The E3D should be inserted from the bottom and snapped into place. It may take some force, but it holds well. Once installed, insert the teflon feed tube and cut off at the top of the holder (just below where the extruder drive gear is).
There are mounting holes for the single and dual extruder plates.
The E3D should be inserted from the bottom and snapped into place. It may take some force, but it holds well. Once installed, insert the teflon feed tube and cut off at the top of the holder (just below where the extruder drive gear is).
There are mounting holes for the single and dual extruder plates.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
