Slicer Discord
Free Board Games & Card Games STL Download - RING TOSING DRINKING GAMEby GT 3D Makers – Modelo 3D imprimible de Creality Cloud Creality Cloud

Free Board Games & Card Games STL Download - RING TOSING DRINKING GAMEby GT 3D Makers

por
0 Descargas
0 Likes
0 Makes
Ver Modelo
3D MODEL DESCRIPTIONSpend fun evenings having fun with friends with this skill game!The goal of the game is simple, succeed in throwing your ring so that it stays attached to your hook to score a point and make your opponent drink!Material :-1 Base with score slots-1 Portion of pillar with notches for hooks (Low pillar)-2 hooks-Classic pillar portion(s) (High pillar)-2 Upper part-2 String blocker-2 Ring (size of your choice)Set up :A video is being filmed. In the meantime, here are the written explanations =>Mount the pillar with the holes for the hooks on the base.Put the two hooks in place, positioning them with their points upwards.Add as many classic pillars as desired. 2 pillars are recommended. The number of pillars influences the height of the game, and therefore its difficulty.Snap the 2 upper parts together, then assemble this new part at the top of the pillars. Be careful to position the holes with the smaller side down.Choose a ring size, or take a key ring, and attach a sewing thread to it, leaving enough length.Pass the end of the wire through one of the holes at the top of the structure, from below and block it by inserting a wire lock from above. To find out the length of thread needed, place the ring in place in the hook, and pull the thread little by little to tighten it slightly. The ring should not jump off the hook. The different holes allow for different difficulties.Rules of the gameThrow your ring delicately. If it gets stuck in your hook you score a point. Move your opponent's points marker one space closer.You must not guide the ring too close to the hook so as not to make the game too easy. If the ring is positioned on the hook, but falls alone immediately afterwards, the point does not count. The ring must hold in place!Goal of the gameTo win, you must score points faster than your opponent so that the score marker moves out of the points track on their side.Want to increase the difficulty?-You have several sizes of rings available. The
Fuente
Creality Cloud
Publicado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección