Ritewing Big Drak stuff

These are all parts I designed and currently have printed and installed on one of my Full size (Big) Ritewing Drak's

The nose piece is modular. This setup is designed for an HDZero Micro V2 camera and the HDZero 1 watt Freestyle VTX. THe VTX is mounted on top of the nose for ultimate airflow. The antenna mount sits on top of the VTX and is designed to keep the u.fl - SMA connector as short as possible for low signal loss. You can swap the front nose piece and switch between HDZero and Analog (1.3 or 2.4 ghz for example) in under 5 minutes if you run the wiring for the analog camera during the build process.

My set up uses a Matek F405 Wing (the original 2019 version pre-plandemic) and I run an APD 120F3[x] ESC.

The "Hatch-Latch" part is for securing the equipment and battery bay coroplast covers while still maintaining almost ALL of the room in the equipment bay. Glue (E6000) in place and then glue the nut-certs into the "Hatch-Latch"

The Equip-Hatch-Scoop-r1" part is prin