Rivet Drilling Guide - and construction set

Rivet Drilling Guide - and construction set
If you print this, please post a photo on the 'I've made one'. Thanks!

This is a drilling guide to get evenly spacing holes from 1/2 inch to over 2 inches.

I made the 10-hole version. for a 20-hole version, you will need to add (two each) connector rod 5 hole and a lot more connectors part 1 and 2. I used different color for the drill holes to aid in counting the holes to be drilled.

The things you can make with these are almost endless. Shown are an earlier version of the rods connecting to make a boomerang. An 'erector' set could be made by adding a few 90 degree connectors. Let me know if you want me to add these.

On the earlier versions, I was trying some alternative designed connectors. These did not work as well as the two-piece connectors. I did glue the newer version together but the fit is tight enough that glue is optional. For the 'Erector Set' you may want to try press fitting only.

For the 10-hole versi