Thingiverse
RobinStand v1
door Bearloot
28
Downloads
24
Likes
0
Makes
My initial Robin Stand design, printed and tested at 100 microns and printed on its side for minimal support. Not a lot of clean-up was needed.
USB port / mic and notification light is left open and there is enough space for a thin case. I've tested with "Scratches case" and it's a nice fit.
USB port / mic and notification light is left open and there is enough space for a thin case. I've tested with "Scratches case" and it's a nice fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
