Thingiverse
Robo3D Bed Strain Relief
von ThorMJ
8
Downloads
3
Likes
0
Makes
This strain relief snaps between the slide and the printbed, so you don't have to worry about ABS-Juice permanently affixing it if you don't want to.
Be sure to cut the support out of the notches otherwise you'll have a hard time snapping it in place.
Be sure to cut the support out of the notches otherwise you'll have a hard time snapping it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
