Thingiverse
Robo3D Spoolholder Endcap
door DasWookie
16
Downloads
8
Likes
0
Makes
The Robo3D comes with a spoolholder, but not an endcap to contain it on the horizontal shaft. This results in the spool being able to walk off the end and crash down. This is a small endcap which is easy and quick to print, and then no more worries about loosing your spool off the holder.
One side has a inset for the 1/4x20 screw.
One side has a inset for the 1/4x20 screw.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!