Roborock H7 Wall Mount

The Roborock H7 Pure stick vacuum did not come with a wall mount and a wall mount is not available for purchase. This wall mount can be wired to charge the vacuum when the vacuum is inserted or the wall mount can be used just as a hanger for the vacuum.

Print settings that worked for me:

1) No supports
2) Layer height = 0.2 mm
3) Infill = 20%
4) Perimeters = 6

To wire the wall mount, you will need:

1) One large paper clip cut to two U-shape (see paper clip photo)
2) Two 10-inch wires
3) One 5.5mm x 2.1mm female power connector (usually available on-line for under $1)
4) Solder and a soldering iron

Steps for wiring:

1) Push U-shaped paper clips through the 1½mm holes from front to back
2) Solder one wire to each of the paper clips
3) When looking at the back and right side up, attach the left paper clip wire to the positive (+) terminal of the 5.5mm x 2.1mm power connector and the right paper clip wire to the negativ