Roborock S6/S5 Max Base

A remix of [a remix of the Roborock Docking Station](https://www.thingiverse.com/thing:4541071) to fit even smaller printing beds.

The remixed split version was made for CR10 and it did not fit on my Creality Ender 3 S1 bed size of 220mm by 220mm by 270mm, so I made a few adjustments to make it fit diagonally and upright on smaller beds.

Note: Each Q piece did take about 18hrs or so to print.

20% infill was fine, except for the dowel and screen parts, for which I used 100% infill for extra strength.

Printed with PLA.

Add supports for the overhanging dowels only on Q1, Q2 and Q3 pieces. (If enough demand, I might remix it so that all the dowels are printed completely separately from the base pieces, in order to eliminate any need for any supports).