Thingiverse
Robot Arm Electronic Enclosure
door 3Dutz
1
Downloads
1
Likes
0
Makes
Electronic enclosure for the robot arm by 20sffactory or ftobler.
I know its not the best design, it can be a little tricky to put to arduino and ramps in place with the reset button but its doable :) Maybe will make some changes in the future.
Everything is printed without support except the reset button. The yellow parts are glued to the white middle case part. M3 screws used.
I know its not the best design, it can be a little tricky to put to arduino and ramps in place with the reset button but its doable :) Maybe will make some changes in the future.
Everything is printed without support except the reset button. The yellow parts are glued to the white middle case part. M3 screws used.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
