Robot arm SLS

This is the SLS version.

I hope you will enjoy this as much as i did LimpSquid did a awsome job here I just modified some small parts. :)

This is the material list of what i used.
Part....... Pieces
Berring 628....... 5
Berring 6200....... 2
M3 nut ....... 44
M3x8mm ....... 16
M3x10mm....... 12
M3x12mm....... 27
M3x16mm....... 22
M3x20mm....... 2
M3x30mm....... 2
M3x40mm....... 2
Servo 180 degrees 35Kg....... 3
Servo 180 degrees 20Kg....... 3
Servo 360 degrees....... 1
10mm Steelball....... 10
Arduino uno ....... 1
Sub_d 15pin male ....... 1
Sub_d 15pin female....... 1
Capasitor 470UF 25V....... 2

Remote
Toggle on/off/on switch....... 1
Toggle on/off switch .......1
On/On Switch ....... 1
10K sliding resistor....... 5
Resistor 1K ....... 5
Capasitor 100n ....... 5
Wire 0,22 m2 ....... A lot

Here is the original arm.
https://www.thingiverse.com/thing:1748596
https://www.thingiverse.com/