Slicer Discord
Robot Keychain with LEDs – Modello 3D stampabile da MakerWorld MakerWorld
Robotics

Robot Keychain with LEDs

6 Download
8 Likes
0 Makes
Vai al Modello
Hallo,ich habe hier ein Remix des sehr schönen Roboters nun mit LEDs in den Augen und Energie Rucksack.Benötigt werden 2x 3mm blink LEDS, ein Stück Nickel Streifen 4 mm und 2x AG13/LR44 Knopfzellen.Das Batteriefach hat zwei Seiten, eine bei der Nickel Streifen durch den Boden geht das ist Plus Seite, die andere Seite an der Nickel Streifen seitlich raus kommt in Minus, bitte beachten.Den Nickel Streifen am besten von unten durch ziehen und dann am Rand oben umbiegen. -------- Hello,I have here a remix of the very nice robot now with LEDs in the eyes and energy backpack.Needed are 2x 3mm blink LEDS, a piece of nickel strip 4 mm and 2x AG13/LR44 button cells.The battery compartment has two sides, one where the nickel strip goes through the bottom that is plus side, the other side where the nickel strip comes out sideways in minus, please note.It is best to pull the nickel strip through from below and then bend it over at the top edge.Translated with DeepL.com (free version)
Categoria
Robotics
Fonte
MakerWorld
Pubblicato
Aggiornato
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Piano min.
50 mm (Piccolo)
Software
Cura, PrusaSlicer o simile
Stesso designer, più piattaforme

Caleb_3D pubblica anche su

34 modelli aggiuntivi su altre 3 piattaforme

Verificato dalla corrispondenza dei titoli dei modelli tra le piattaforme.
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione