Thingiverse
Rock64 Case with fan support
von basty2
23
Downloads
11
Likes
0
Makes
Case for Rock64.
I made a case with support of a fan, because of overheating. I used a cooltek 4010 working by temperatures over 60 degrees.
I used m3 screws and nuts for the fan and 35mm m3 screws to put both parts of the case together. I didn't used nuts for the case. Maybe this will be stronger. For me this solution is fine.
honestly, I made my case with cheap china PLA (was delivered with creality cr10) for test reasons. But I am satisfied.
I made a case with support of a fan, because of overheating. I used a cooltek 4010 working by temperatures over 60 degrees.
I used m3 screws and nuts for the fan and 35mm m3 screws to put both parts of the case together. I didn't used nuts for the case. Maybe this will be stronger. For me this solution is fine.
honestly, I made my case with cheap china PLA (was delivered with creality cr10) for test reasons. But I am satisfied.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
