Thingiverse
Rocker Switch Mounting Block
por 4l52sauerd
2
Descargas
2
Likes
0
Makes
When implementing LED strip lights on my printer enclosure, I wanted a good solution for mounting the power switch that incorporated its recessed design and also On/Off indication.
This block will mount an NKK SW3001A (or similar) from the back using its existing flange, and the entire assembly will mount to the panel with an oversized hole for the switch and wires.
Added a taller version to better fit the side of an Ikea Lack enclosure at 45mm tall. This version also warped much less than v1 when printed.
This block will mount an NKK SW3001A (or similar) from the back using its existing flange, and the entire assembly will mount to the panel with an oversized hole for the switch and wires.
Added a taller version to better fit the side of an Ikea Lack enclosure at 45mm tall. This version also warped much less than v1 when printed.
4l52sauerd también publica en
3 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!