Thingiverse
Rocket ID Badge Holder
von boothstreetboy
0
Downloads
0
Likes
0
Makes
fits 1 or 2 badges/cards
no supports needed if printed rocket-side down
made for standard ID card/badge sizes [2 1/8] X [3 3/8]
i included an stl file without the rocket design as well
i usually swap colors out during the 3rd layer
general shape based on jrebeiro's design. this is a full re-model with more card capacity and looser fitment, bevels, modeled to use no support, and the rocket design (the extent of my artistic ability).
no supports needed if printed rocket-side down
made for standard ID card/badge sizes [2 1/8] X [3 3/8]
i included an stl file without the rocket design as well
i usually swap colors out during the 3rd layer
general shape based on jrebeiro's design. this is a full re-model with more card capacity and looser fitment, bevels, modeled to use no support, and the rocket design (the extent of my artistic ability).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
