Thingiverse
Rocket Lamp
door Phrillseeker
9
Downloads
5
Likes
0
Makes
This rocket lamp is best printed in two colours on a dual extrusion 3D printer - use software like "Simplify3D" to slice and print two colours.
The attached photos should show how the whole thing is put together.
You will need to purchase some electrical supplies (I shopped on Aliexpress) and you must know how to solder and wire everything together:
- 1 x 12Volt LED bulb 3.5watt GU5.3 model (50mm diameter)
- 3 x 12Volt LED bulb 1.25watt GU4 model (35mm diameter)
- soldering iron + solder
- thin 12V wire (3 x 20 cm)
- black power cable (1m)
- power supply: 12V transformer, 10watt with 1m of cable
- switch
- option: drill small holes and glue glass fibre cable in holes and connect together so that the main light shines through the glass fibres and makes pretty pin pricks of light all round
The attached photos should show how the whole thing is put together.
You will need to purchase some electrical supplies (I shopped on Aliexpress) and you must know how to solder and wire everything together:
- 1 x 12Volt LED bulb 3.5watt GU5.3 model (50mm diameter)
- 3 x 12Volt LED bulb 1.25watt GU4 model (35mm diameter)
- soldering iron + solder
- thin 12V wire (3 x 20 cm)
- black power cable (1m)
- power supply: 12V transformer, 10watt with 1m of cable
- switch
- option: drill small holes and glue glass fibre cable in holes and connect together so that the main light shines through the glass fibres and makes pretty pin pricks of light all round
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!