Thingiverse
Rocket Launch Rod Guide
von Ender3Prints
0
Downloads
0
Likes
0
Makes
This is a Launch Rod guide for a model rocket, the side with the flattened edge (triangle) points upwards and a screw is inserted into the side of it while the rod goes up through the bottom.
It is for launch rods up to 3mm in size
It is for launch rods up to 3mm in size
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
