Rocktopus Octoquad

Here's the Flite Test Vlog:
https://www.youtube.com/watch?v=-H76d7_7qSs

Watched the vlog and saw how they cut and hollowed it out post printing and taped the head back on and figured I could tidy that process up a bit.

I added holes in the bottom for wire routing (not pictured) and redesigned the motor mounting to hold different sized motors. The screw slots have a maximum spread of 23mm center to center and will fit M3 screws.

The inner cavity is 83mm wide at the thinnest point so there shouldn't be any FC placement issues either.

Overall it's a bit bigger than the original. When I imported the stl and did the mesh conversion the size got blown up to a few hundred percent so I scaled it down and it's not perfect but the motor measurements are sound.

This is a LARGE print (v12 files). At it's greatest extents it is 450mm wide, around 350mm rotated, which as of this writing is not good! I'll need to be shrinking this down since cutting it in half to print kinda defeats m