Thingiverse
Rod End Tool Bit
door Equim
3
Downloads
1
Likes
0
Makes
Basically just added a hex-shaped piece to the original to fit in 1/4" bit holder and smaller electric screwdrivers without and adjustable chuck.
Probably won't be as strong as the original but it worked when I tested it and they are fairly cheap to make extras of.
I personally printed it laying down flat (making sure the hex bit has a flat piece towards the bed) with supports.
It might be a snug fit to make it fit into the bit holder, I had to trim it a bit with a knife to make it fit properly, along with pushing it down against a table for the first use at least. But it also means that it won't fall out constantly unless it gets worn down.
Probably won't be as strong as the original but it worked when I tested it and they are fairly cheap to make extras of.
I personally printed it laying down flat (making sure the hex bit has a flat piece towards the bed) with supports.
It might be a snug fit to make it fit into the bit holder, I had to trim it a bit with a knife to make it fit properly, along with pushing it down against a table for the first use at least. But it also means that it won't fall out constantly unless it gets worn down.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!