Thingiverse
Rod holder
von GoToTheWall
11
Downloads
8
Likes
0
Makes
A simple rod holder for all of your rod holding needs.
Strong enough, but probably don't do pull ups off them. Or do, I'm not your dad (pls dont sue).
Pictured on my janky DIY coat rack, don't judge.
Modeled to hold a rod with a diameter of 1" (2.54cm), scale the print to fit whatever you're trying to hang. Use the following equation:
(Desired diameter / Original diameter) x 100 = Scale%
Strong enough, but probably don't do pull ups off them. Or do, I'm not your dad (pls dont sue).
Pictured on my janky DIY coat rack, don't judge.
Modeled to hold a rod with a diameter of 1" (2.54cm), scale the print to fit whatever you're trying to hang. Use the following equation:
(Desired diameter / Original diameter) x 100 = Scale%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!