Thingiverse
Røde transmitter clip
von Zeilsteen
0
Downloads
1
Likes
0
Makes
If you have a broken Røde Wireless Pro or Wireless Go clamping clip this is the thing to print.
You do need the spring that is probably still on the device. Pull the pins out of the device and install it in the holes of the print.
Stick the two smaller pieces of the spring inside the device and let the wider side press on the upside of the transmitter.
You maybe need to make the holes a litte bigger if you print to heavy. I printed it 100% infill.
ZEILSTEEN>COM radio
You do need the spring that is probably still on the device. Pull the pins out of the device and install it in the holes of the print.
Stick the two smaller pieces of the spring inside the device and let the wider side press on the upside of the transmitter.
You maybe need to make the holes a litte bigger if you print to heavy. I printed it 100% infill.
ZEILSTEEN>COM radio
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!