Thingiverse
Rogue Crown
von Givaneo_Arts
0
Downloads
2
Likes
0
Makes
This is the crown I designed and wore with my D&D rogue costume for Renaissance Faire.
It's a relatively fast print (mine took about 2 hours to print) with no supports needed.
> - Make sure you print the crown with the spikes facing upwards.
> This allows the crown to print flat on the buildplate with no supports.
The inner-diameter of the crown is 19cm (about 7.5in), so adjust the XY-axis scale accordingly to fit your head size.
I included a test ring ("Test_ring_for_crown.stl") so that you can experiment with various scales without wasting filament.
It's a relatively fast print (mine took about 2 hours to print) with no supports needed.
> - Make sure you print the crown with the spikes facing upwards.
> This allows the crown to print flat on the buildplate with no supports.
The inner-diameter of the crown is 19cm (about 7.5in), so adjust the XY-axis scale accordingly to fit your head size.
I included a test ring ("Test_ring_for_crown.stl") so that you can experiment with various scales without wasting filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
