Thingiverse
Roku Extender
von mrbillv56
4
Downloads
7
Likes
0
Makes
Created this for my arthritic wife who has a hard time hanging onto the tiny roku remote.
It is an interference fit that requires a good push to get the remote installed.
We have tested this on multiple types of Roku remotes including Sharp and TCL roku TVs and a couple of generic 3rd party roku compatible remotes for roku boxes that also control our old dumb TVs.
Only one had issues and a bit of sanding at the contact points took care of that.
I have printed this in both PETG and PLA on my Prusa Mini.
It is an interference fit that requires a good push to get the remote installed.
We have tested this on multiple types of Roku remotes including Sharp and TCL roku TVs and a couple of generic 3rd party roku compatible remotes for roku boxes that also control our old dumb TVs.
Only one had issues and a bit of sanding at the contact points took care of that.
I have printed this in both PETG and PLA on my Prusa Mini.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
