Thingiverse
roll holder
von liradigital
5
Downloads
3
Likes
0
Makes
Custom roll holder
you will need :
2x M5 nuts
M5 threaded rod (27cm in my case, depends on the roll´s width)
7 screws
Tip: I used a cardboard tube over the rod for a smooth rolling
you will need :
2x M5 nuts
M5 threaded rod (27cm in my case, depends on the roll´s width)
7 screws
Tip: I used a cardboard tube over the rod for a smooth rolling
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!