Thingiverse
Roller Blind Clip
by chickenbeef
0
Downloads
1
Likes
0
Makes
Recently did a DIY roller blind install but wasn't having any luck getting the glue to permanently stick the material to the roll - it would come off after a few months.
Created this simple clip that goes over the fabric and clips onto the roller. This puts less strain on the glue to hold the thing up.
Printed a few of them and spaced them out evenly on the rod.
Created this simple clip that goes over the fabric and clips onto the roller. This puts less strain on the glue to hold the thing up.
Printed a few of them and spaced them out evenly on the rod.
chickenbeef also publishes on
9 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
