MakerWorld
Other House Models
Zum Modell
Rollerblind Bracket
2
Downloads
1
Likes
1
Makes
A simple replacement bracket for your rollerblind. Screw to the wall using the two holes in the bracket, then slide the rope in as pictured. As the print will likely be located in or around direct sunlight, i would recommend you use PETG (or anything other than PLA) to prevent rapid UV degradation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
