Rolling Pin Handle

This thing was made with Tinkercad. Edit it online https://v1.tinkercad.com/things/eV0JHNeLWaM

One of the wooden handles on our Marble Rolling Pin cracked after many years of service. The rolling pin has a metal rod that goes through the marble roller, with plastic washers on each side that center the rod so that the handles run smoothly through the center. The rod extends completely through the marble roller and into the handles on each side.

I reproduced the handle close to the original design but this resulted in the handle breaking at it's narrowest point. Since it was printed with the handle pointing upwards(tall), the layering was the weakest point, when it broke it broke cleanly on a layer. I had two choices, try printing it lying down (so the layers run lengthwise, making layer weakness along it's length) or to increase the width of the handle near the breaking point (I did this instead).

Print this with the handle tall on the bed, with the hole for the rod facing down