Thingiverse

RollUp Mount Replacement Part

par dalbyte

2 Téléchargements

0 Likes

0 Makes

## Need:

**1** M3 16mm
**1** M3 nut
**1** M4 washer

The screw only serves as a support for the plastic so that it does not break so easily due to layer alignment. Cap (3) then closes the hole as a lid.

Hopefully you can see in the photos how it is intended. Cap needs a bit of force, I closed it with a small clamp.

I have printed everything in **PLA**.

## Parts:

0 mirro of 1 mirro keypart
3 is cap
4 is dual mount
5 mirro of 6 single mount

## Dual Mount

I split the bracket that has a holder on two sides in the middle and then pressed it with dowels in slicer is not ideal but it works.