ROLLX Dice Tower

ROLLX Dice Tower and Faceplate.

Fulfilling my personal desire to design a windowed dice tower to see the die rolling action.

First design was a plinko style with many pegs. but I didn't make them far enough apart and 12-20 sided dice were stuck in the chute. Scrapped that and went with this model, the ROLLX (for the X shape from the bumpers that create two paths for the dice to take). Made sure the channels were wide enough and went to town.

The Faceplace/Cover should be printed face down and no supports required. I used a heated glass bed for smooth finish on the front.

The Tower can be printed on its back (as I did) or vertically (probably better) with only supports needed for the two diamond bumpers in the center. If you use Cura the experimental "tree" support can waste minimal material.

The screw holes are designed for #4 x 1/2" wood screws. Depending on your machines dimensional accuracy, you may need to drill out the holes a little more to make the screws