Rome Binding Underwrap Highback Mounting Hardware

DISCLAIMER: I do not under any circumstances recommend the use of 3D printed parts downloaded from the internet in real actual snowboarding, and I am uploading this thing solely for use as a display/aesthetic piece for an incomplete snowboard binding set. IF YOU DO DECIDE TO USE THIS PIECE, YOU DO SO SOLELY AT YOUR OWN RISK!!!

Uses a M5x20 screw and a nut. Tends to loosen a bit over time, so a lock nut is useful here. I used this with Rome SDS 561 Targa bindings and it seems to fit ok, but I am only testifying to my own limited experience.