Thingiverse
Rook Card Box
door JFZoidberg
8
Downloads
12
Likes
1
Makes
This is a remix of markus_p's UNO Card Box (https://www.thingiverse.com/thing:5850150).
The inner box can be glued to the bottom, but this isn't necessary. The inner box has a small dot on one of the long sides, which should face forward. Note also that Outer Box - Latch should be printed twice.
As far as hardware, 6 M3x30mm screws are needed. Lastly, fill with Rook cards (https://a.co/d/gcN9wJx).
The inner box can be glued to the bottom, but this isn't necessary. The inner box has a small dot on one of the long sides, which should face forward. Note also that Outer Box - Latch should be printed twice.
As far as hardware, 6 M3x30mm screws are needed. Lastly, fill with Rook cards (https://a.co/d/gcN9wJx).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!