Thingiverse
Roomba Bumper
von Magnatic
15
Downloads
9
Likes
0
Makes
Does you Roomba get stuck on low ridges? With this bumper you lower the standard bumper to about 1cm.
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed, layer height 0.3mm
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed, layer height 0.3mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!