Roomba Wrangler

This is a bracket to stop your Roomba from pushing its dock around when trying to get home. Designed for Roomba 980 dock. There is a fit check piece that you can print to check if the dimensions will fit your base station - the fit check uses 4g of filament (about 10 cents worth).

Once you're happy it fits then print the main part, slip it over the base plate and use two screws to secure it to your skirting board. I made mine with PLA.

Note that there is a 2 degree draft angle on the base so orientation is important; the radius along outside edge of the bracket is the top side. Or just try it both ways - should be pretty obvious which orientation gives the best fit.