Roomy ESP32 Enclosures

There is plenty of ESP32 board enclosures out there, but most of them are quite streamlined/minimalistic, which is fine but I set out to buid an enclosure with a little more room in it so you can easily use breadboard jumpers instead of soldering, more slack in your wiring to make it easier to pull the Dev board out and make adjustments etc.

It is 58.5mm wide x 83mm long and 52mm tall (54.5mm with lid), The 4 standoffs for mounting your ESP-32 board are 35mm tall (1 ⅜ inches) giving you plenty of room for your breadboard jumpers, on top of the standoffs are pins that align and allow your ESP32 to “snap” into place. I adjusted this until it was easy to set the chip in, while still doing a good job of holding the dev board in place. There is extra space at the end of your ESP32 so that you can wire in a Level Shifter and keep it tucked away in this enclosure.

The lid has the negative space of the inside of the enclosure protruding down to line up and securely hold the lid in p